Quantum and Thermochemical Structure lap report Assignment

Quantum and Thermochemical Structure lap report - Assignment ExampleBecause of the difficulty of maintaining clean metal surfaces under(a) vacuum, quantitative amount of moneyments of the photoelectric effect could not be made for many decades. However, as technology improved, it became translucent that the energy of ejected electrons was not related to the intensity of the well-fixed waves apply, and also that below a certain light frequency - for a given material - no electrons at all could be ejected. Eventually it became affirmable to determine the relationship between the kinetic energy of the ejected electrons and the frequency of light used to eject them, and this was unmatched of the major factors leading to the development of the quantum model. The kinetic energy of photoelectrons (E) can be pulsed by find out the voltage required to just stop the ejection of electrons (V) and multiplying this by the charge on an electron (e). comparison 1 V (J C1) x e (1.602 x 101 9 C) = E (J) Experimentally, the habituation of E on frequency turned out to be Equation 2 E (J) + k1 (J) = k2 (Js) x ? (s1) Where k1 was different for every metal and k2 was exactly the same for every metal. Whats more, k2 was exactly the same as a fudge factor that had been introduced into a theory developed a few years former to explain a completely different phenomenon. In this experiment you will carry out alone measurements to determine k1 and k2. Unlike early 20th century researchers, you will not need to spend some(prenominal) years constructing your apparatus from scratch, but will use a demonstration apparatus designed to measure the fillet voltage of electrons ejected from Cs3Sb in a vacuum. Experimental The EP-05 photoelectric effect apparatus was used to measure the stopping voltage of light at 8 different wavelengths. A modified spectrometer was used t o provide UV-visible light. The wavelengths tested were 400 nm, 425 nm, 450 nm, 475 nm, 500 nm, 525 nm, 550 nm, a nd 575 nm. The photoelectric apparatus was set up such that the aperture in front of the photodiode was positioned near the light source. The dials with labels zero and voltage was set to minimum earlier the shutter was closed. The plotting was initiated using the Lab View window. The voltage dial was set to maximum while the some other dial was turned until nanoampere readings reached zero. The voltage dial was set back to minimum before the shutter was open to increase the nanoampere reading to 10. The voltage dial was maximized once again to recheck that the zero dial was adjusted properly. erst everything was set, the stopping voltage was minimized and the plotting of nanoamperes versus stopping voltage was reset and started at the Lab View window. The issue current in nanoamperes were determined by slowly turning the voltage dial. The measured current was record and then plotted according to its stopping voltage reading. The measurement is ended when the critical value for stopping voltage where there is minimal change in nanoamperes with respect to voltage is achieved. The whole procedure was through with(p) for each of the 8 chosen wavelengths. Results The experiment was done properly and all the needed data were acquired. The numeric values obtained from the use of the apparatus can be found at the attached document. The plot of the graphical record and the summary of the derived values are the following Figure1. Compiled plots for output current versus stopping